Weelko B-Equipment cosmetic device for facial BIO lift tightening
Weelko B-Equipment cosmetic device for facial BIO lift tightening
Code: F317A-
A beauty device with high-conductivity gloves that restore skin elasticity and a facial BIO-lift function that removes wrinkles, scars and marks.
Technical information:
- Weight: 2.1 kg
- Size: 20.5x22x7 cm
- Input voltage: 220 ~ 240V
- Input frequency: 50Hz / 60Hz
- Nominal power: 4W
- Adjustable intensity (10 levels): 50 - 600µA
- Power frequency: 2W
- Operating frequency: 0.1; 5; 10; 20 30; 60 e 120 Hz
The massage, which is performed with high-conductivity gloves, improves the structure of the skin, thereby activating fibroblasts and, as a result, increasing the amount of collagen and elastin. Massage also helps the product penetrate. The "BIOLifting" function creates contractions, the facial muscles achieve a clear tone. In both cases, a conductive gel or other lotion that corresponds to the skin type is required.PACKAGE SIZE cm
37x27.5x14
NW Kg
2.1
GW Kg
2.6This product meets the following requirements:
1. The conditions laid down in the Low Voltage Directive: 2014/35 / EU
2. Conditions set out in the Electromagnetic Compatibility Directive: 2014/30 / EUInstructions for use of gloves:
1. Connect the half of the cable to the plug labeled "BIO WAVE MICROCURRENT" on the rear panel.
2. Connect the other two ends of the wires in each glove.
3. The beautician must put insulating gloves under the gloves of the B-Euipment device
4. Make sure the ENERGY level is at minimum. You can adjust the output level by pressing "ENERGY +/-".
5. Make sure the FREQUENCY level is set at 0.1 Hz. You can adjust the frequency level by pressing "FREQ".
6. Select the desired wave state by pressing "STATE". There are 4 types of waves.
7. Select the operating time by pressing TIMER +/-.
8. Press START / PAUSE to start the procedure.
9. The beautician must massage the client with B-Equipment gloves. Adjust the ENERGY and FREQUENCY levels according to the client's feeling. At that time, the client should feel micro currents and heat in the area where the treatment is applied.Use of BIO-lifting:
1. Connect the half of the cable to the plug labeled "BIO WAVE MICROCURRENT" on the rear panel.
2. Connect the other two sides of the wires to the BIO lifting nozzle. There are two types of nozzles:
• For those who need cotton swabs are used in the eye area. Two cotton swabs should be inserted
• Having only one pin, are used in the body area.3. Apply enough conductive gel to the treatment area.
4. Make sure the ENERGY level is at minimum. You can adjust the output level by pressing the ENERGY +/- button.
5. Make sure the FREQUENCY level is set at 0.1 Hz. You can adjust the frequency level by pressing "FREQ".
6. Select the desired wave state by pressing "STATE". There are 4 types of waves.
7. Select the operating time by pressing TIMER +/-.
8. Press START / PAUSE to start treatment.DOWNLOAD INSTRUCTIONS
Love it? Share your thoughts in a review!Write Review